| |
|
 |
 |
| The main frame of the bender is made from 4 x 2 rectangular tube as it nicely fits flange bearings |
good view of the motor mount, bearings on both sides and 1″ main shaft |
 |
 |
| motor secured to the mounting flange and sprockets in place on both shafts |
The motor was an extra I had on the shelf, but it is a 12vdc 300w one with a gear reduction ends up outputing 75rpm @ 19N.M before which was to fast for bending so the additional step down chain and sprockets gives about another 3 to 1 advantage. |
 |
 |
| |
On a stand without a scroll jig attached |
 |
 |
| |
|
| |
|
